SGS Electrical Measurements test the performance of electrical and electronic components under environmental simulations such as vibration, climatic aging and corrosion. Our tests comply with major original equipment manufacturer (OEM) specifications including BMW, VW, Daimler, Renault and Nissan, PSA, Toyota and many more.
We work to global standards including ISO and IEC, to test for:
Resistivity
Surface and/or transverse resistivity measurements are used to characterize the ability of a material to conduct electricity.
Contact Resistance Measurement
Resistance generated by a contact, or a crimping, can cause the destructive heating of a connector. We measure such resistance using a direct current source and a microvoltmeter.
ElectroStatic Discharge (ESD)
A high voltage generator, a charge bar and an electrostatic field meter evaluate dissipation (or not) of these charges in a part.
Dielectric Strength
These tests verify the maximum value of the electric field that a material can withstand before the triggering of an electric arc, thus a short circuit.
Insulation Resistance
Measuring insulation resistance in electrical equipment allows manufacturers to identify potentially damaging faults or defects.
Electrical Continuity
These tests check an electrical component remains operational when subjected to severe environmental conditions.
Other Measurements Performed in Our Laboratories
- Ground continuity
- The rebound time of a switch
- Heating temperature
Photometry
Innovations in headlamps, signaling and light sources require adapted safety solutions for the automotive industry. We offer the following solutions:
- Test lamp intensity and distribution
- Test retro-reflector performance
- Luminous flux
- Color
- PF
- Test luminance
- Check of exterior plastic materials of the automotive lamp
- Diffusion
- Transmission
Our laboratories also offer monitoring options for continuous recording of input and output parameters during testing:
- High speed data acquisition/monitoring/continuity
- High end oscilloscope
- Data logger
- Voltage drop/resistance/current
- Temperature
- Powering capabilities DC voltage supplies
- AC/DC electrical/electronic loads
Why choose SGS for your automotive electrical measurements?
We are the world’s leading testing and verification company, with laboratories, testers and industry experts located throughout the world. Our network is ISO/IEC 17025 accredited and approved by OEMs on this testing scope.
Noor Tower (2nd, 6th – 10th & 13th Floor),
110, Bir Uttam C R Dutta Road, 1205,
Dhaka, Bangladesh